Septic System:

• Installed per supplied design. Inspected by local code enforcement.

Driveway:

• Up to 100’- Gravel base 12’ minimum width with approximately 4" of top coat crushed gravel. Crowned at a minimum of 5:1. Longer drives, turnouts, or large parking areas quoted individually.

• Culverts placed at drive end per town specs. Additional required culverts placed as required and priced on a case-by-case basis

Utility Trenching: (if required)

• Up to 100’- (1) Power conduit-2"  and (2) Low-voltage conduits-1"

Foundation:

• 8’ walls 8" thick (10" over 38’ long)

• 4" thick slab floor, cut for stress cracks.

• All ties snapped off inside and outside the foundation. Ties below finish grade filled from the exterior with dry-lok or equivalent hydraulic cement. Entire surface of foundation to be below grade will be coated with an asphalt foundation coating.

• Standard pre-cast bulkhead with BILCO Steel cover, left as primed.

Drainage:

• Drains- 4" Rigid Schedule 20 perimeter drains inside and out side footing. One floor drain in corner of floor.

• Stone- minimum of 4" of crushed stone in basement floor and stone around perimeter drains, inside and out covered with hay, straw or filter fabric.

• Drains run out to grade level where possible. A small retention pool may be required. Home sites where gravity drainage will not work will be taken on a case-by-case basis.

Backfill:

• Clean coarse sand will be used to fill around the foundation perimeter and the foundation floor.

• Fill from cellar hole will be used on site where possible for bringing a lot to grade.

• Excess fill will be brought on-site as required. The initial quote will have allowances for bringing the excavated perimeter of the home to grade.

• A 25’ perimeter around the home will be covered with loam and seeded. A 12" wide 4" deep layer of crushed stone can be placed around the foundation for splash and drainage for an additional charge.